Hi folks,
I'm stuck in a place: i'm unable to send images from Conquest to a remote server as conquest has to send through a firewall.
I keep getting: AETITLE did not accept the connection.
Anyone has tips to avoid this?
Hi folks,
I'm stuck in a place: i'm unable to send images from Conquest to a remote server as conquest has to send through a firewall.
I keep getting: AETITLE did not accept the connection.
Anyone has tips to avoid this?
Hi,
any dicom-move reverses the connection. I.e.
caller opens connection to called
caller send dicom-move request
called opens connection to caller <---
called send dicom image
called closes
caller closes
the step with <--- requires a reverse opening in the firewall. Hope this explains.
Marcel
You have to open the ports on the remote firewall to foreward to the server.
Best is to open the ports only for the sending and receiving IP or just use a VPN connection - last one is the safest and most preferred if going over WAN
Can anyone tell us as to what are the ports used by Conquest when communicating with a remote server.
Need this info to open up the ports on a firewall (UTM).
Port 11112 is the port that has been configured & also opened on the UTM.
These are the port set in the config page an the port of the remote server
mardfel
Don’t have an account yet? Register yourself now and be a part of our community!