Posts by vauxmd

ok on the wildcard matching, but would the ExportAccessionNumber = X line work?

Would the following work:

ExportAccessionNumber0 = *L*
ExportConverter0 = forward patient to ILHRADV

Thanks. I will give of these at try.

this routing works, but overall it has slowed the routing of studies to the workstations. The server this is sitting on, in a 64bit Server 2003, quadcorex2, 16GB RAM, with dual ethernet ports; so I really don't think it's equipment issue. Would there be any way to streamline the routing any?

thanks

Also along those lines, woudl the following work:

ExportConverters = 3

ExportCallingAE0 = *
ExportConvertoer0 = forward to IHDMRAD1;DCM4CHEE

ExportCallingAE1 = IM*
ExportConverter1 = forward to IMMCRR1V;IMMCRR2V;IMMCRR3V;IMMCRR4V;IMMCRR5V;IMMCRR6V;IMMCRR7V

ExportCallingAE2 = IL*
ExportConverter2 = forward to ILHRADV;ILHCTV

Thanks

Ok another thought in the "ExportConverterX = forward to " line, can I use something like the following "ExportConverter3 = forward to IM*" ? I have a few workstations that all begin with the letter IM.

Thanks will give that a try.

I have a situation where I need to route images from different locations to the same mammo reading stations, plus have ConQuest route those images to two different PACS servers. Looking through the manual, it appears possible, but I'm not sure how to properly program this in the dicom.ini export section.
Here is the image flow needed:
1. Images from two locations sent to ConQuest server
2. Images from location A (county hospital) need to route to Hologic reading station AND to PACS A (Amicas)
3. Images from location B (OP imaging center) need to route to Hologic reading stations AND PACS B (Centricity)
Both sites have unique accession numbers, and all mammo units are uniquely named.
Help