Posts by antai2005

  • cannot add a new dicom node

    Hello, IP address of one of dicom nodes changed. I tried to update ip in K-pacs, but I found the new ip can not be saved. I can change it, but once I restart k-pacs, the old ip came back.
    Do you know what I should do ?
    Thanks

  • the image viewer does not work

    Thank you, Stridde, for your suggestions. I did find a port number conflicting on that PC that I installed K-Pacs. I reinstalled K-PACS on another computer. This time, I got the server status indicator in green all the time. However, my viewer still does not show any images. After I queried the images on another server, I checked the series from the patient list and then hit the viewer tab on the left side. The loading status bar came out with 0%. After one minute (I did not see the percentage in the status bar changing. It stays the same to be 0% all the time) , a black screen came out without any image except the name of the patient and image series showed in a yellow bar with an arrow pointing down.
    Did I not use the viewer correctly ? Do I need to save the images to the imagebox before I can view it ? Can I view the images showing in the patientlist that I queried from a remote server. I do not know how to save images to the K-Pacs imagebox.


    Thank you again


    An

  • the image viewer does not work

    Hello, I installed K-Pacs 1.6 on a PC running XP SP2. It is able to query dicom images on another server and send them to the treatment planning system. However, I can not view the images in K-pacs. If I select a image set and hit the viewer tab on the left side, it starts to load images (I can see the status bar). However, no image was shown up in the display window, which is all black. In addition, the server status (on the right bottom corner) indicator is always red, meaning that the server is not running.
    Do you know if I missed something in the installation of K-Pacs.
    Thanks
    An